FAQs Häufige Fragen an uns

Fragen dazu Fragen dazu

All FAQs (1757 total: showing 1621-1640)

If a device or sensor is not available for selection in the Short Cut program, how can it be added?
Can the datalogger be damaged by wiring the sensors to the wrong ports?
How can a floating point value be cast as a long integer?
How can data that has been transmitted from a datalogger to LoggerNet then be transmitted to a webhost that displays the data graphically?
Is there a way to only record measurements during the daytime and put the datalogger in sleep mode during the nighttime to conserve power?
What is checked during the calibration of a Campbell Scientific datalogger?
Is it possible to use LoggerNet Admin software to connect to, and display data from, multiple dataloggers?
Can a datalogger be contained in a waterproof enclosure?
What does the PreserveVariables instruction do?
Can more than one SDM device be connected to a datalogger?
Can Campbell Scientific dataloggers be used with a telemetry system to remotely download data, check parameters, etc.?
Can binary data be received via the serial terminal of a datalogger?
What might cause a CRBasic datalogger to stop storing data?
How can the amount of time before the memory of a datalogger is filled be calculated?
What are the rules regarding when data is deleted from a datalogger?
What is a USR drive?
What needs to be done to get a CR3000 program to run on a CR9000 or CR9000X?
If a CR3000, CR1000, CR800, or CR850 has TLS enabled and connects to a server whose certificate is not verified by a “trusted” signer, what will the datalogger do?
If a CR3000, CR1000, or CR800-series datalogger has a “machine self-calibration failed” message, what does that mean?
Can CR3000, CR1000, CR800, or CR850 digital terminals be configured to act as RS-232 terminals?

Vorhergehendes Nächstes