FAQs Häufige Fragen an uns

Fragen dazu Fragen dazu

All FAQs (1757 total: showing 1601-1620)

How can several SDI-12 instruments be wired to a single datalogger terminal?
Can a CR800 wiring panel be used on a datalogger other than the original datalogger?
What is the maximum supply voltage of a CR800 or CR850 without damaging the data logger?
Why do the example programs for the WXT520 use a scan rate of 5 seconds?
Why do the values from the WXT520 seem to be out of order?
If the wind speed on the WXT520 constantly reads 0, what should be done?
Is LoggerNet software needed to download the data from a datalogger remotely?
Can the constants located within the ConstTable/EndConstTable instructions be edited?
Can the display timeout and contrast be programmed by the CRBasic Editor?
Can the CR800, CR850, CR1000, or CR3000 upload to an FTP site on scheduled intervals?
Is it possible to connect the CR800, CR850, CR1000, or CR3000 to a SCADA system through a Modbus RS-485 protocol?
How can the CR800, CR850, CR1000, or CR3000 be configured as a Modbus RTU server?
Is it possible to overwrite an existing array using a CR850?
Can the NL201 be put into bridge mode via the settings of a CR800 or CR850?
Can the CR850 be programmed to show information in the display without using the keyboard?
Can a new program be installed on a datalogger using a laptop and PC200W?
When no excitation is commanded, are the voltage excitation ports on the datalogger isolated from the datalogger ground?
Instead of saving the data of a CRBasic data logger to one large file, how can it be saved in daily, hourly, or half-hourly files?
If a computer does not have any serial ports, how can software (such as LoggerNet, PC400, PC200W, or Device Configuration Utility) talk to the datalogger?
Can external devices be switched on and off using a datalogger?

Vorhergehendes Nächstes