FAQs Häufige Fragen an uns

Fragen dazu Fragen dazu

All FAQs (1757 total: showing 361-380)

What needs to be done to measure ST350 Strain Transducers using a Campbell Scientific datalogger?
What is the microstrain limit for the ST350?
Is one 4WFBS350 or 4WFBS120 required for each ST350 connected to a datalogger or multiplexer?
When should a guy kit be used on a CM106B?
When the GPSReady variable is not 10, does the data logger still synchronize with the PPS signal?
If the “pps” field returned by the GPS() instruction usually displays “990000,” what might be the cause?
If the “gps_ready” output of the GPS() instruction is stuck at or near zero and the datalogger clock is not being set, what might be the cause?
How can latitude and longitude data from a GPS16X-HVS receiver be recorded on a data logger and then parsed out?
How can four GPS16X-HVS receivers be connected to the COM ports of a datalogger to read all four NMEA strings?
Does the regulator for the 25295 draw power from the battery during the night?
Does the regulator for the 25295 have the Low Voltage Disconnect feature?
What would happen if two dataloggers were connected directly through CS I/O ports via an SC12 cable?
What is the pinout for the SC12 cable?
Can a solar panel provide enough power to charge a weather station?
Can the 41303-5A 6-plate radiation shield or the 41003-5 10-plate radiation shield be used with the HMP155A-L?
To connect the HMP155A-L to a CR800 or CR1000, should a differential or single-ended channel be used?
After reinstalling LoggerNet, why might the RTMC file no longer see any dataloggers under LoggerNet?
After installing an RTMC patch, what would make the text and label look fuzzy?
Is there a way to send email from a data logger and simultaneously monitor other data from the data logger using RTMC display?
What is the difference between the Connect screen graph and the RTMC chart?

Vorhergehendes Nächstes